Spicer 5-1350X U-Joint Kit 1350/SPL30 Series (OSR)

They fit perfectly and are built well

This is what was installed from the factory.I was debating between these and the greaseable ones, went with the non-greaseable ones since the originals lasted 20 years and don't want to worry about having to grease them.Between these and the moog u joints these seems to be better made, specifically the end caps are more sophisticated compared to moog. If you want greaseable spicer makes em with the zerk in the end cap

Does not fit rear drive shaft (2 piece). Ordered 3 to replace all u joints in rear. At first glance they seem to be the same size but they are too small. Installed one and the side to side slop from the u joint sliding back and forth between the needle bearing trunions was so bad some needle bearings fell out in the cap.Upon closer inspection, by comparing old U joint to the new 1350x, it became clear that I had the wrong replacement part.Rushed to advanced auto parts and luckily they had three Moog 295 u joints that fit perfect. I would have preferred to stick with Spicer but needed my truck on the road. Honestly, Moog is a solid brand so I am not concerned about it. Just sucks to waste about $100 because I bought the parts months ago and cannot return. Also, the 1350x I had to remove from the driveshaft (the one I installed) is not going to be able to be reused, so had to toss it. If you want to stick with Spicer I believe the 1410x is the part you need but for sure Moog 295 fits.I am not for sure yet, but I think the 1350x may work on the front drive shaft. I will find that out when the time comes.Just throwing some information out there for everyone. I spent a lot of time scouring for info through old forums and it all lead me back to wrong u joint, and it was. I do not hold Spicer accountable and they are still my go to brand for my truck and probably always will be. Moog is a close second. This one's on me.

Installed it today on my 1985 M1008. Fits wonderfully, no more annoying sounds coming from the rear axle. Would buy again.

But no longer needed them

no problems for 2014 Ram 1500

Expensive but fixed clunk in 2011 Suburban

Part was an exact replacement. Installed in a Ford E350.

Smooth as silk now!

يركب الفورد f150 خلفي

I only use spicer balljoints and ujoints, always top quality.

Rebuilt my 4x4 drive shaft on a 2004 f-350 fit and worked perfect.

I love Dana quality. My driveshafts will be good for another 300 000 km